Ceramics are generally used to make some decorations, we can use this material to make many exquisite bottles and so on. With the continuous development of technology, ceramics, as an excellent material, will be naturally used in our industrial production. In this process, it is important to use this material. Ceramics are also common in…
There are many kinds of fine atomizing nozzles, which are suitable for humidification in textile factories, printing factories, electronics factories, laboratories, painting workshops, tobacco industry, etc. , improve production quality and production efficiency. In the use of fine atomizing nozzles, the following five aspects should be paid attention to during the process 1. If the…
The greenhouse humidification and spray equipment can effectively control the humidity and temperature in the greenhouse, effectively adjust the plant growth environment, promote crop production, and use the high-pressure spray system to solve the problem of cooling in the greenhouse in hot seasons. The greenhouse humidification and spray equipment cools down through the cold mist…
Problem 1: The automatic spray gun jumps during the spraying process Analysis of the reasons: 1. The automatic spray gun is not tightened or installed properly; 2. The needle seal kit is loose; 3. The coupling nut of the automatic spray gun is loose (under the spray gun); 4. The paint in the pot is…
The special internal structure design of the air atomizing nozzle can make the liquid and gas evenly mixed to produce a spray of fine droplet size or a spray of coarse droplets. Typically, a finer (under 50 micron) droplet spray is obtained by increasing the gas pressure or decreasing the liquid pressure, resulting in a…
1. Observe from the water pump to see if there is a pressure drop or pressure rise. The change in pressure drop means that the nozzle mouth is severely worn and the water volume becomes larger. The pressure rise represents a blockage of the nozzle orifice.2. Observe from the appearance of the nozzle, whether the…
If the spraying workshop in our working environment is too dry, static electricity will be formed, which will affect the effect of spraying. If the spraying workshop is too dry, a large amount of dust will be generated, which will have a great impact on the smoothness of the sprayed surface. For humidification in the…
The internal structure of the stainless steel air atomizing nozzle is specially designed, so that the liquid and gas can be fully mixed together. Even without changing the air and liquid pressure, two different spray shapes are sprayed. The stainless steel atomizing nozzle can spray fine and uniform atomized particles, which can improve the environment…
The spray type coverage area formed by the Full cone nozzle is circular, square or oval, and the area is completely filled with spray droplets. This type of spray is usually created with internal vanes. The vanes allow controlled turbulence of the liquid before the nozzle orifice. Full cone coverage can also be obtained using…
Reasons for nozzle damage 1. Erosion. When the liquid with high flow rate passes through the metal surface of the nozzle hole, it will erode the nozzle hole, causing the nozzle pressure to decrease and the spray state to become irregular. The probability of nozzle erosion depends on the hardness of the liquid, the spray…
